how much boost on an ecotec - Boost Forum

Forum Post / Reply
You must log in before you can post or reply to messages.
how much boost on an ecotec
Friday, January 25, 2008 7:29 PM
i was just wondering how much boost can an ecotec handle and also what would you classify a t25 garret turbo t3/t4 also how much spray can you run

Re: how much boost on an ecotec
Friday, January 25, 2008 8:46 PM
All depends on your set up .


A clear cut question is going to be very hard to give you , until you give every specification of your set up.

Injectors, fuel pump, etc etc.






Re: how much boost on an ecotec
Friday, January 25, 2008 9:14 PM
one hundred million psi.....seriously it rocks




As the above poster pointed out it all depends on your setup and such. Id say that 10 psi is a safe estimate but 10 psi from one turbo isnt the same as 10 psi from another so meh..
Re: how much boost on an ecotec
Friday, January 25, 2008 9:51 PM
highrever wrote:i was just wondering how much boost can an ecotec handle and also what would you classify a t25 garret turbo t3/t4 also how much spray can you run

A lawnmower turbo.


-

"Youth in Asia"...I don't see anything wrong with that.
Re: how much boost on an ecotec
Friday, January 25, 2008 11:05 PM
I have the stage 2 kit from hahn racecraft on my 04 and im running 8psi. I heard i could run ten psi pretty safely but never did. This car is for sale check the classifieds
Re: how much boost on an ecotec
Friday, January 25, 2008 11:38 PM
That is such a broad question that it makes it almost impossible to answer. There are so many different variables that will determine how much boost your engine can handle. You could run 5psi and blow up your engine if you don't know what you are doing. Me personally, I wouldn't go past 10psi on a daily basis due to our @!#$ty ring lands



Proud member of Jbody of Kentucky ... Click on sig to go!
Re: how much boost on an ecotec
Saturday, January 26, 2008 9:03 AM
Depends on what the t25 came off of. Your turbo will be a limiting factor here. Past that the eco should handle up to 15psi depending on your injectors.


_________________________


Forum Post / Reply
You must log in before you can post or reply to messages.

 

Start New Topic Advanced Search