Will these injectors work on an Eco setup??? They look like normal Bosch style, but I've never heard of "purple tops" Anyone ever use these???

Specs :
Injector Body Design: Chrome and composite plastic
Flow rate: 65lbs/hr - 680cc/min at 43.5 psi
Flow rate: 69lbs/hr - 725cc/min at 49 psi
Electrical connector type: EV1
Length: 3 inches, 74 mm
Diameter: 24 mm
Orings: Top and bottom, 14.5 mm
Resistance: 4.5 to 5.8 Ohms
(All fuel injector specifications meet or exceed the manufacturer's specification standard).





Currently #4 in Ecotec Forced Induction horsepower ratings. 505.8 WHP 414WTQ!!!
Currently 3rd quickest Ecotec on the .org - 10.949 @ 131.50 MPH!!!

Those would be something I wouldn't mind owning.

Quote:

Resistance: 4.5 to 5.8 Ohms

with that spec NO , as they are not high ohm injectors

high ohm are in the 10-12 range

They probally will fit but there only 4.5 ohms to 5.8 I think ecotec are 14-16ohms. Better off getting the ones off of racetronix.com.Cost about the same.

Or get them and just run resistors.


"Never argue with an idiot. They'll drag you down to their level, then beat you with experience!" -Anonymous

I'm an idiot!!!! I completely forgot about the Eco's being high impedence! That's especially bad since I knew that when I bought my 44 lb/hr Accell injectors. BRAIN FART!!!!

Anyways, what about THESE ones???


FEATURES:

Genuine, reliable Siemens Injectors
Excellent response characteristics
Robust Design
High Impedance
Low Impedance performance characteristics with High Impedance Compatibility
Specifications:
Coil Resistance: 12.5 Ohms / High Impedance / High-Z (No ECM driver modifications required)
Static Flow Rate @ 43.5PSI ( 300kPa ) w/Gas: 60 lb/hr = 630 cc/min = 453 g/min
Static Flow Rate @ 87PSI ( 600kPa ) w/Gas: 85.7 lb/hr = 900 cc/min = 648 g/min
Gain: 0.11ms/mg
Offset: 0.055ms
Turn on time @ 14VDC: 1.14ms
Turn off time: 0.85ms @ 600KPa
Connector: Standard Bosch EV1
Series: DEKA 4
Orifice Type: Multi-orifice
Spray Pattern: 30 Degree Spray Cone
Viton upper and lower o-rings






Currently #4 in Ecotec Forced Induction horsepower ratings. 505.8 WHP 414WTQ!!!
Currently 3rd quickest Ecotec on the .org - 10.949 @ 131.50 MPH!!!

thats the ones I'm getting roofy!



LE61T PTE6262 Powered

Copycat!!!!! But seriously, what is about the upper horsepower limit on these? I also have an Accel adjustable fuel pressure regulator.




Currently #4 in Ecotec Forced Induction horsepower ratings. 505.8 WHP 414WTQ!!!
Currently 3rd quickest Ecotec on the .org - 10.949 @ 131.50 MPH!!!

those 660s could support 400 whp easily according to skunk + adjustable fpr which equals more



LE61T PTE6262 Powered