hey org people . im currently in a turbo project for my 96 ld9 and im at the point about to change my injectors .. i have some 450cc from a donor dsm talon , and i just have a quick question .. how much boost will the stock injectors hold ? thanks
Well they question would be how long would the stock injectors hold the motor together...what are you running, tc or sc? how much boost? It is recommended that no amount of boost be ran on the stock injectors/fuel system.
Someone knows the stock injector mass flow rate, but I do not.
If you used an FMU and a stronger fuel pump you could get by on stock injectors for a few pounds of boost but if you have other mods etc you may as well get the bigger injectors on there.
heavyclutch wrote:Someone knows the stock injector mass flow rate, but I do not.
If you used an FMU and a stronger fuel pump you could get by on stock injectors for a few pounds of boost but if you have other mods etc you may as well get the bigger injectors on there.
im TC the car and i do have a 255 wali , afpr and safc2 running at the moment and the set of 450 cc sitting .. just wanted to know if i could squeeze the stocks one a bit under boost ..
i was planning on running max boost on my dsm 16g (small one ) which is i think 12 safe but i know that for sure i will have to change the injectors under that much boost
I would not run more than 6psi on stock injectors with a FMU. If you have bigger injectors then use them.
FU Tuning
John Higgins wrote:I would not run more than 6psi on stock injectors with a FMU. If you have bigger injectors then use them.
thanks i was just wondering
agreed 3-5 lbs on stock from what I have heard and proper fuel mods. Use those larger injectors asap with 12 lbs of boost.
