Just picked up a hahn 20g turbo and I wanna order up the coolant port fitings and oil feed fittings for it. assuming they are metric? every other turbo i have had was 1/8npt for the oil feed line, but the 20g's is much larger. as for coolant ports im guessing m12-ish x 1.5?

anyone happen to buy these recently and know what size they are?

go herehttp://store.forcedperformance.net/merchant2/merchant.mvc?Screen=PROD&Store_Code=FP&Product_Code=49178-01760&Category_Code=Turbo-Mitsu

mainly just after thread pitch for the two holes. not after a kit. i will be ordering individual fittings from summit or jegs

thanks for the link tho

no, click on turbo accesories i think on left side and find fittings,click on fittings seperately to get sizes

I have a set of coolant lines with fittings ill sell you for a Mitsubishi Turbo. And the thread pitch for the oil inlet should be M12X1.5. PM me if interested in the lines.




Currently #4 in Ecotec Forced Induction horsepower ratings. 505.8 WHP 414WTQ!!!
Currently 3rd quickest Ecotec on the .org - 10.949 @ 131.50 MPH!!!

took the turbo with me to ACE Hardware and just threaded some metric bolts in the holes..

oil feed is just as was stated above: m12x1.5

coolant jackets are m14x1.5

hope the info will be usful to someone else at some point in time