Holy cow it's been a long time since I've been in here, anyway, right to the point. Once again I've run into a problem that I can not figure out and I am relying on the infinite wisdom of the people on this website. While doing a routing check under the hood of my 95 cavy 2.2 5spd I noticed the nut on the tranny mount on the driver-side (kinda under the master cyl.) was loose, after looking I noticed the bolt that holds that onto the tranny was completely gone. I have tried all the bolts I have laying around the house, read every shop manual I can get my hands on, and even contacted the dealer, no one can tell me what size thread this bolt is. The dealer said an m10x1.25, but the m10 falls right in the hole, at least 1-2 sizes to small. If anyone knows the size, or has one easily excessable they could get the size of it for me I would be greatly thankful.


~champ~


<img src=http://donut.parodius.com/agtp/images/GonMad.gif>
What makes you think I'm crazy?

Go to the dealer and get the bolt or grab one off of a junk yard car.

Take one of your stock ones which you have left, go to any autopart store or like a home-depot get grade 8 or better bolts and you will be fine.

I'll say go to a junk yard. Faster and cheaper, sometimes free!!!!





stock '00 2200 cavy

I got one from the junkyard, but I need to lift the tranny to put it in, any ideas of where to put the jack without damaging anything?


<img src=http://donut.parodius.com/agtp/images/GonMad.gif>
What makes you think I'm crazy?

Anywhere on the tranny, you will put very little pressure on it just moving it up an inch or so. Just go slow.