Dear J-Body Enthusiasts...

I would like to have a braided stainless-steel line fabricated for my clutch actuator pipe. To know if this is feasible (then I could route the line differently and eliminate isuues with rubbing, etc), I need to know what types of fittings are at the ends of the clutch pipe. Yes, I know, someone will probably tell me "Why don't you remove the one from your car and take a look?" -- Understandably, I was hoping to avoid this.

Does anyone have a clutch pipe that is sitting around? Might you be able to take a few close-up pictures of the end fittings?

This would be very helpful!

Sincerely,
illtmprdman

BTW: My car is an 04 Cavalier Coupe