quick question. i have just got my clutch and flywheel installed and i do not feel like they did the job right because i received the car with a higher and lighter feel then when i left it. and that is the problems what should a spec stage2 and fedaz flywheel feel like should it not be closer to the firewall when you feel it to start disengaging? and when i shift should it should like i am over reving the car between shifts because of the lighented flywheel. well all answers are thanked. i just want to make sure that they really did the work on my car and not just took my money. so again what kind of pedal feel should i get from the spec state 2 flywheel on the 99 cavalier? thanks.
sorry did you not want me to pass you?
Well it's stiffer for sure..not much but you can feel it in the pressure needed to push the pedal.
As for over reving sound??? ..i really don't know what you mean by this ..but it does rev faster..i can hear a different tone to my exhaust, and it pulls harder at low rpm..decompress's faster too..but again slightly
ne-waz hope this answers your question ..if not, sorry dude but i just don't understand what your asking
SPEC clutches let out near the top, thats normal. The overrevving thing is porbably cause if the flywheel. I dont think anything is wrong there.
____________________________________________________________________
Madjack wrote:Like I said before, building an engine like ours (2.2 or 2200) is a painstaking chore , since there is so few custom made parts. It's frustrating to me too, but that's what I like about doing this engine, it's the challenge.
ha thanks man i was starting to worry. But ? is it the same for center force?
sorry did you not want me to pass you?
not sure about the centerforce, but that over reving will go away once you adapt to the new clutch. And yes mine releases right at the top. I know its a completely different car, but my brothers clutchmasters in his accord releases right on the floor.
yeah i had issues with my spec stage 2 when i did my install. It was slipping like crazy and grabbed at the top. Well after ripping the trans 3 times total and installing a new fidanza flywheel it was all good after the break in.
*2012 mazdaspeed3*
