anybody know the correct torque specs for a pressure plate on a 04 getrag? help please!
Tighten the bolts to 20 Nm (16 ft. lbs.) .
Rotate 45 degrees .
Tighten the bolts to specifications in a star pattern.
one more question. after the pressure plate bolts are torqued to specs should the clutch disc still be able to move with the alignment tool? mine does and i've never seen a clutch do this before. then again i've only done clutches on a RWD not a front. help please!
When i did my clutch install my disc stayed put...it didnt move. double check and see if anything has gotten in the way by chance, or that the disk is facing the right direction.
what i mean is that i can put the alignment tool into it and rotate it. it doesnt move up and down it just rotates..is this normal?
Idk I never tried to spin it when I installed mine to be honest. sorry man.
My 04 factory service manual says 24 N-m or 18 lb-ft.
