So it has came to my attention from Jeffie that our passenger side axles are no longer made as the correct assembly. So I went looking locally around here, and no one but one Autozone had any stock, and of the 11 they had only one that looked correct.
Added now...Old pics came from Matt, "GlowingCavy: Boosted Z" Thanks man.
So this is old and new ends. Wheel end.
Trans end Old vs new.
P/N on the new box.
Notes from Autozone site.
Part Number: 8498N
Weight: 15.75 lbs
Warranty: Limited Lifetime
Application: With automatic transmission
Location: Front
Position: Left
Length: 23 7/32 in. (590 mm.)
Length Measurement Method: Compressed
Outboard Spline Count: 33
Inboard Spline Count: 34
Inboard Joint Type: Female
Spindle Nut Size: M20 x 1.5
Includes: Spindle nut
Abs Teeth: 48
Edited 2 time(s). Last edited Thursday, April 26, 2012 3:43 AM
- Attachments
- IMG_8321.jpg (300k)
PRND321 Till I DIE
Old Motor: 160whp & 152ft/lbs, 1/4 Mile 15.4 @88.2
M45 + LD9 + 4T40-E, GO GO GO
The end in question that is the correct one. All the other ones everyone had are the grand am length...
- Attachments
- IMG_9939.jpg (296k)
PRND321 Till I DIE
Old Motor: 160whp & 152ft/lbs, 1/4 Mile 15.4 @88.2
M45 + LD9 + 4T40-E, GO GO GO
P/N for the only one that is correct.
- Attachments
- 20120426_060031.jpg (361k)
PRND321 Till I DIE
Old Motor: 160whp & 152ft/lbs, 1/4 Mile 15.4 @88.2
M45 + LD9 + 4T40-E, GO GO GO
Axle end.
- Attachments
- 20120426_060201.jpg (282k)
PRND321 Till I DIE
Old Motor: 160whp & 152ft/lbs, 1/4 Mile 15.4 @88.2
M45 + LD9 + 4T40-E, GO GO GO
Trans end.
- Attachments
- 20120426_060155.jpg (285k)
PRND321 Till I DIE
Old Motor: 160whp & 152ft/lbs, 1/4 Mile 15.4 @88.2
M45 + LD9 + 4T40-E, GO GO GO
Another trans end pic.
- Attachments
- 20120426_060123.jpg (280k)
PRND321 Till I DIE
Old Motor: 160whp & 152ft/lbs, 1/4 Mile 15.4 @88.2
M45 + LD9 + 4T40-E, GO GO GO
So this is for the jack shaft setup? My understanding was they did away with it and went to a one long piece design?
