Im trying to save some money by ordering these myself, rather than through a tranny shop. I do not want order the wrong ones either, so i thought id ask here.
Im looking at part#'s below on www.rockauto.com
Do we need input seals for the Getrag?
Input shaft seal TIMKEN Part # 222835- rockauto
With the jackshaft setup, we need 3 output seals right?
Output shaft seal TIMKEN Part # 100165- rockauto
They also have input and output shaft repair sleeve(the black seal beside the slave/tob) as well
But they list 3 different sizes, which one is our correct one? and the one we need, is it an input or output?
Input shaft repair sleeve
TIMKEN Part # KWK99111
Output shaft repair sleeve
TIMKEN Part # KWK99138
SKF Part # 99138
NATIONAL Part # 99139
~2014 New Z under the knife, same heart different body~
______________________
WHITECAVY no more
2012 numbers - 4SPD AUTOMATIC!!
328 HP
306 TQ
Not sure on the input shaft... but with the output shaft wouldnt you only need two seals for the transmission... then whatever the jackshaft takes... i have no clue what it takes. And the repair sleeves should only be for if you have grooves worn into the shafts..
Thanks Jordan. Yea the Jackshaft takes 1 output seal. I may just let the tranny shop decide if I need the repair sleeve.
~2014 New Z under the knife, same heart different body~
______________________
WHITECAVY no more
2012 numbers - 4SPD AUTOMATIC!!
328 HP
306 TQ
Don't know what year your car is but my 89 has a 91 hm-282 and I got my seals from autozone for $3 a piece abd tapped them in. Be sure to put oil on them before tapping them in.
On the inside my car looks like a fighter jet.
That my be a cheaper option minus shipping, thanks Rob! Its a 2000 2.4motor and Getrag trans setup.
~2014 New Z under the knife, same heart different body~
______________________
WHITECAVY no more
2012 numbers - 4SPD AUTOMATIC!!
328 HP
306 TQ
I'm like 75% sure the input shaft seal is Integral to the slave/ TOB. Might be removable but then again I've never tried. I think I have a spare slave or 3 laying around the garage if u need one.
Currently #4 in Ecotec Forced Induction horsepower ratings. 505.8 WHP 414WTQ!!!
Currently 3rd quickest Ecotec on the .org - 10.949 @ 131.50 MPH!!!
If you are going through autozone order 3 or 4 of them. One I got from them was bent and I didn't realize it till I went to install it. One I damaged trying to install. It isnt hard just have to take your time. You can always return them if you dont use them. Mine I had to order they did not keep in stock. It only took a day to get.
On the inside my car looks like a fighter jet.
