Does anyone have a picture of where they spliced into the wires off the coil pac for a tac adaptor? I have looked at the autometer tach adaptor and there saying different color wires that i have. Its a 99. If anyone has one or could get one, i would be very thankful. I don't want to cut somthing i don't! Also not sure after what plug into the coils it needs to be done to...

Thanks in Advance!!!!

anyone?

Im in the same boat! lol... i need pics too for my light still


-----------------------------------------------------

98' Pontiac Sunfire SE

Well i just spend the last 30-40 min diggin through old posts on this for us.

IXI187IXI wrote:well you have the same engine is me and i did it on mine. Took me about 15 mins to do. On your engine on the right side of the coil pack there is 2 harness's. A 2 pin and a 6 pin. You have to cut the pink wire on the 2 pin harness and hook up each red wire from the adaptor. Then ground the adaptor and run the other wire to the tach. After that just run your power and ground for the tach and thats it. You'll need a tach adaptor and make sure to get the autometer one. If you need more help check out my car domain page, i have pics of it on there because so many people have asked how to do it. Check it out of you need help .

Does this look accurate to anyone who has done it before?

that is exactly what i was looking for, holly crap! gj man


-----------------------------------------------------

98' Pontiac Sunfire SE

hold up, so both red wires off that adaptor are going to that one pink? and that pink still connects to the pink? and wheres the yellow come in?


-----------------------------------------------------

98' Pontiac Sunfire SE