ok i got 5 switchs i am going to put in the z24 for good reasons 2 are going to be for cold cathodes 1 for front foot wells and the rear floor,2 for kill switchs and one for some thing i won't say yet. but where is the best place to put them they have to be hidden
If you want them hidden from view, why not put them inside your center console?
98 Z24
RIP Specks
i put all my switchs and such right by the trunk release button.
Big Boi -Coloradojbody.org- wrote:i put all my switchs and such right by the trunk release button.
Lucky punk. I dont have a trunk release button.
I have a switch pad for my inner neons on the center consoul, and 2 more on the dash for the Fogs and 1 for the G.
i dont have stock power windows but mine are in that lil center piece b4 the console
it kinda dips in, and I have 3 in there ..i usally keep a paper or two, sometimes my
cell so really you never see dem
Depending on their size, you could mount them inside your ashtray.
alkatmsu wrote:Depending on their size, you could mount them inside your ashtray.
thats what i was thinking but when u close the ash tray the metal thing close so i would have to fiberglass some thing to make it look right
wtf
i dont have an ash tray
i have this cup thingie for the ashes that sits inside one of my 2 cup holders..
all my switches sit on my passenger seat
LarryMartin830 wrote:alkatmsu wrote:Depending on their size, you could mount them inside your ashtray.
thats what i was thinking but when u close the ash tray the metal thing close so i would have to fiberglass some thing to make it look right
That metal part pulls right out. You can then take apart the hinge on top of it, that'll give you a bit more room on the top of it to work with. Drill holes in the metal, install your switches into/onto it, run your wires under the metal, and it'll give it a very clean look.
alkatmsu wrote:LarryMartin830 wrote:alkatmsu wrote:Depending on their size, you could mount them inside your ashtray.
thats what i was thinking but when u close the ash tray the metal thing close so i would have to fiberglass some thing to make it look right
That metal part pulls right out. You can then take apart the hinge on top of it, that'll give you a bit more room on the top of it to work with. Drill holes in the metal, install your switches into/onto it, run your wires under the metal, and it'll give it a very clean look.
ahhh thats it thanks i never thought of that
Ozzie(aka LED KING) wrote:wtf
i dont have an ash tray
i have this cup thingie for the ashes that sits inside one of my 2 cup holders..
mine don't have them i took the ash trays out of both cars theres no smoking in my cars but i have the thing where the ash tray sit and i wanted to put them there
