i know everyone says that can just break off those little tabs to get the cloth part off of the door, but i was wondering how people were doing this, i am using a screwdriver and it pops off in little pieces and dosent work too good at all, does anyone have a better method, im trying to get all the cloth off my door ie the armrest part and the holders in the bottom, thanks.

I just took the cloth out with a lot of muscle! There are a couple screws (why???) holding the cloth down on the bottom part. But other than that, just pull hard.

i used a 1" chizel (sorry im a bad speller)

Dremel

Propane Torch

steak knife once. a screw driver once. dremel the other times.



(Insert really cool picture of my car with some catchy name or slogan here)

screwdriver, knife, and brute force!!!




Stock '00
2200 cavy
sedan!!!!

on those type pieces i just use a heat gun to melt them then pop them off, then when i want it to go back i just reheat the tab and mush it back down.


http://www.flickr.com/photos/sndsgood/ https://www.facebook.com/#!/Square1Photography