i have searched and can not find it any where but what wires do you connect off of the SPAL power door lock kit to wire to the oem switches. I know with the spal kit you do not need to wire them to switches but i would like to and was wondering if anybody has already done it. I saw a wiring diagram on another kit but that was a 2 wire actuator and this one is a 5 wire. I posted in the audio and electronics forum but havent got any response. Any advice or help would be much appreciated.

the SPAL kit is the same at the autoloc kit in wiring. So the same should apply. This is a quote from the autoloc GP thread.

Quote:


Rousseau9099
Sunday, February 04, 2007 10:55 AM

Yes, you can use stock switches. What you have to do is find the main ground on the switch then the lock and unlock ground. When the Lock and unlock is grounded it works the actuator. I will post a diagram for you later when I get oustide to take a pic of the switch. Also if you need help installing the kit itself pm or email me and I will do a write up for installing them, I took pics when I did mine so that should help you out.

The black wire on the autoloc kit is ground. I believe the green and blue are the solenoid wires. So the white and brown are the switch inputs. Like I said this is for Autoloc, But I am sure it works the same for the SPAL kit.