I just got done polishing my fuel rail and my Cartech BEGI FMU for my boost setup. I only have about 1 hour in both of them. The fuel rail still needs buffed with some more mothers but overall i think it looks good. I also have a polished ecotec cover you can see on my cardomain page.
Good job on that thing...I've got mine off right now too getting ready to hit it and the valve cover.
Eh...old man with a Corvette now...it was bound to happen sooner rather than later right?
Ill give you a tip...buy all wet sand paper and just put it under running water...start with 320 then to 400 after you get the pits out and then just go straight to 2000 then buff with mothers. Mine only took me 1 hour from crap to that.
Is that the factory ECO fuel rail ? If so I know what I'm doing this weekend !
AWESOME JOB !!
Semper Fi SAINT. May you rest in peace.
Thanks for the tip...I'll be hitting mine this weekend as well!! Hope it turns out like that!
Eh...old man with a Corvette now...it was bound to happen sooner rather than later right?
now what did i start...... hmmmmm
I as planning on doing the turbo as well wrench but i might just hold off till i get the turbo installed and working before i put all the time into polishing it and it getting all dinged up during the install.
Thanks for that tip!
Can't wait for the snow to go away!
