Hi all,
I'm in the middle of removing my intake resonator (bong) and I'm stuck cause it won't budge, so I will continue tomorrow to 'play' with it until I can remove it completely. Meanwhile, I have to use the car and it's currently raining outside, can I drive the car without the fenderwell liner or is it better not to have water in this area ?
put it on just to be safe, not like it takes a long time anyways.
GO PATS!!!
You hane to take out the washer bottle cause theres one bolt that hods the two together that you just can't reach. Good Luck
Semper Fi SAINT. May you rest in peace.
i just used a dremel and cut the SOB out...
GO PATS!!!
Yea like jackalope said there are two you cant see and are a bitch to reach.
____________________________________________________________________
Madjack wrote:Like I said before, building an engine like ours (2.2 or 2200) is a painstaking chore , since there is so few custom made parts. It's frustrating to me too, but that's what I like about doing this engine, it's the challenge.
When i took the bong out i cut it right at the neck where it goes into teh engine bay and then just ripped it out. i didt worry about disconnecting it from the washer tank.
Driving with out the liners won't hurt it. I have cold air and no liners and I drive in the rain all the time. No problems.
I just gotta watch for puddles.
