Avenger front / gas door relocation - Exterior Forum

Forum Post / Reply
You must log in before you can post or reply to messages.
Avenger front / gas door relocation
Friday, May 20, 2005 8:12 PM
Hey guys. I am wondering if anyone could tell me how low the Avenger front is. How far is it from the ground? How does it compare to the drift kit in height?

Also, I am relocating my gas door to behind the filler plate beneath the taillight. I am wondering where is the best place to purchase the tubing and what would be the best hinges to use for this project?

Re: Avenger front / gas door relocation
Saturday, May 21, 2005 7:49 AM
i could tell you how low it sits from the ground if you wanna know how far it is while lowered cause i have the avenger front but i am also lowered on sportlines. but i can tell you it's not as low as the drift. the drift i think is the lowest kit, or one of.







Click Here for PIX!!
Re: Avenger front / gas door relocation
Saturday, May 21, 2005 8:38 AM
this is what i got with my setup on goldline springs. the lowest part of the avenger front is 4.5". in comparison, the bomex sides (which are staggered) are 4.5" in the front, and 3.5" in the rear. The drift rear at its lowest point is 3.5". there ya go



-----------------------------------------------------------------------

-----------------------------------------------------------------------
- Sold my beloved J in April 2010 -
Re: Avenger front / gas door relocation
Saturday, May 21, 2005 10:57 AM
TY... that's all I needed to know. I purchased the avenger front and wanted to see how close it would be to lining up with the drift sides. I know the Avenger front lines up pretty well with the Type J sides, so I shouldn't have too much of a problem. As long as it comes decently close, I will be happy. I just really need a urethane front.

Now, does anyone know anything about the gas door relocation? I need to know something about this asap... we're welding my gas door up tomorrow. Still not sure where to get the hose or what kind of hinges to use.
Re: Avenger front / gas door relocation
Saturday, May 21, 2005 11:24 AM
http://www.aplusperformance.com/gasmod.html


These are the instructions I got on it. I am not sure what type of Hinge I would guess a spring loaded one. I haven't gotten that far yet....I got all my materials at a car supply store but I had to get the gas tubing from a marine supply place because car supply store only could get precut hose.

Hope this helps!





UNDER CONSTRUCTION!!!
Check out my site http://members.cardomain.com/lil_z

Forum Post / Reply
You must log in before you can post or reply to messages.

 

Start New Topic Advanced Search