I just recieved my 95-99 drift rear bumper.... but when we put it up there it does not fit worth crap... has anyone else ran into this before?... we have been rouding the center put of the bumper and its getting closer but there is a big gap between the bottom of the trunk lid and the top of the bumper... and i wasnt for sure if we cut out the bottom or not? i would really appreciate some advice.. thanks

sounds like you need some L brackets

every drift rear sags in the middle like that. ive never seen one that fit. mine sagged and all you have to do is buy L brackets and mount them to the bumper support so when you put the bumper on, the top of it rest on the leg of the L bracket and it holds it up. really easy to do

Hehe both of the Drift rear that were on my car sagged HARD. L brackets still made it bad looking. What I did was cut two triangles from the center and then fiberglasses it and cleaned it up. You can't tell at all. But if the L brackets work, then that's better time wise.