I have a set of black projectors on my 95z and the one is fogging up something fierce...is there anything i can do about that other than scrapping them and gettin new ones?
you have a choice, you can drill two small holes in the bottom edge of the lense so it can breathe, or take the lense off and reseal it
run a nice bead of clear silicone around the whole lens. should clear it up....
just make sure the inside of the lights are clear of fogging before you seal it.
Take the housing inside for a few hours to clear it up if its bad, then silicone the hell out of it like Joey said.
or you could check to make sure that the seal between the bulb and the lamp is secure
i see that happen alot
