95 3speed Auto shifting - Transmission Forum

Forum Post / Reply
You must log in before you can post or reply to messages.
95 3speed Auto shifting
Friday, June 30, 2006 7:46 PM
Very tempermental shifting, Doesn't want to upshift at low speeds, if you drop the gas, it will upshift, thoughts on this? I'm VERY new to the Jbody scene, Curious what might be going wrong because it shift perfectly WHEN it shifts.

Re: 95 3speed Auto shifting
Friday, June 30, 2006 10:10 PM
Sounds like the TV cable needs some adjustment/replacement.





Re: 95 3speed Auto shifting
Saturday, July 01, 2006 4:35 PM
Also the car has a miss below like 2k RPM, and Out of curiosity, is there a neutral/park Rev-limiter at 4K RPM?
Re: 95 3speed Auto shifting
Saturday, July 01, 2006 5:22 PM
Yes, there's a limiter in park and neutral at 4,000 rpm.




I was happy when I heard my car ran 10s. Then I found out that was 0-60.
Re: 95 3speed Auto shifting
Saturday, July 01, 2006 5:25 PM
Whats the TV cable? Any other names for it?
Re: 95 3speed Auto shifting
Sunday, July 09, 2006 6:20 PM
SHOoff wrote:Sounds like the TV cable needs some adjustment/replacement.


Do you have a SHO?
Re: 95 3speed Auto shifting
Sunday, July 09, 2006 6:53 PM
It's the Throttle Valve Cable. It's located below the throttle linkage on the throttle bracket.

To adjust it, depress the button on the side(can be very stiff, I use a screwdriver) and pull the cable out till it hits the stop. Pull the driverside floor mat out and depress the throttle all the way to the floorboard and it will self-adjust. Do not do this with the engine running, you could damage the transmission. You can fine tune the shift points by moving it in or out a couple of clicks, but don't go to far, or damage could result. If you go too far out, it will just pull back in the next time you floor the throttle, putting you back at the stock setting.

If this doesn't fix it, then the could be problems with the valve body itself.





Re: 95 3speed Auto shifting
Monday, July 10, 2006 4:28 PM
Its not that it needs more length, it needs to be shortened... Could i tie a knot to shorten it a bit? Cause with it all the way out it wont upshift till 35, all the way in *away from the TB* like 22...
Forum Post / Reply
You must log in before you can post or reply to messages.

 

Start New Topic Advanced Search