everything i've read says to pull it down at about a 45 degree angle n pull to the side n it should slide right out....well, mine isn't.
any of you guys got some other advice or tricks for me to get this thing out?
thanx
* * BIG FOR SALE POST * *
you gotta push the seat towards the passenger side of the car while you pull it down theres a stub there that it is on and you need to line it up right to get it off.
best way i can think to describe it this early in the morning
In Loving Memory of Phil Martin December 14 2005
Yep just make sure youre pushing it towards the passenger side, and I think it has to be at that certain angle.
you can probably push the coushin in some to see the stud.... thats what i did my first time, and well... its summer time, so my seats out...
...
I took the bottom cushion off (just pull straight up from the front) then unbolted the entire assembly for the back of the seat. Much easier since I couldn't figure out how to get that off either.
http://www.cardomain.com/ride/676422/1
isnt there a clip u have to take off and then you push it toward the pass. side at about 45 degrees thats what I did today and I got a 95 i think there simaliar
I have an 00' and I don't think mine had a clip. Think of it as a toilet paper dispenser
seriously....
It has a knob on both sides and one side is spring loaded. Push hard to both sides and take a look, see if it has a clip. And don't worry about the 45 degree angle, try it all different angles.
Convert 00+ headlights to 95-99
KenwoodKav (1dersk8) wrote: Think of it as a toilet paper dispenser seriously....
.
before any of the females see this...................he's a male he wont know how to change that
i had a difficult time with mine the first time i tried takin it out got pissed of fat it pulled it up n pushed it n it popped right out take ur time you'll figure it out it works at an agle just gotta find the angle so let it alla the way down n pick it up slowly n pushing i to the pass isde at the same time eventually it'll pop
If its there, there's a black clip on the passenger side hinge. That gets removed first.
Then, fold seat to 45* angle while trying to slide the seatback to the passenger side.
When its at the proper angle, it will slide off the driver's side pin.
Installation is reverse.
...............
